Obh draughtmaster manual

Kontrollera anslutningen. Dette tappeanlegget er beregnet til bruk i private hjem og skal ikke brukes profesjonelt. Deretter fjernes trykklokket 2. Ta ut den store gummipakningen i beholderen og skyll den i lunket vann. Lukk igjen tappekranen. Page 39 OBS! Page 42 Det er ikke fat i anlegget.

The draught beer dispenser has been designed for dispensing beer in private homes only and may not be used professionally. Page 49 Preparation of the draught beer dispenser Do not lift the draught beer dispenser by the tap. Instead it should be lifted by the handles 8 on either side of the dispenser. Before use we recommend to clean the drip tray and the stainless steel plate 7 with hot water and detergent.

By switching on the unit without keg , the appliance will cool down and prepare for insert of a pre-cooled keg. Never operate the unit with open lid, but always keep the appliance fully assembled in pre- cool condition.

Page 51 In order to install a keg in the draught beer dispenser push the release button 4 and open the appliance. Tip the container backwards until it rests on the table top. Remove the pressure lid 2 by turning it anticlockwise using both hands as illustrated.

Remove the sealing ring from the container and rinse it in luke-warm water. Page 52 Place the keg inside the container the base plate should face outwards.

Remove the protection cap from the base plate of the keg and take out the tube. Slide the tube through the centre hole of the pressure lid. It is very important that the whole tube is led through the pressure lid. Page 53 The tube is bent outwards slightly to allow for easier insertion in the tap. Slide the tube through the channel in the chromium front of the container. Position the valve of the tube at the point of the spout and insert the valve in the groove of the tap.

Page 54 How to pour beer In order to pour a perfect glass of draught beer, it is essential to start with a completely clean glass without any residue of soap or detergent. Position the glass beneath the tap and keep it tilted in order to get a perfect foam head. Page 55 Remove the pressure lid 2 by turning it anticlockwise using both hands as illustrated. Remove the empty keg which is completely pressed together due to the pressure in the container.

Shake off any excess water — Page 56 Remove the protection cap from the base plate of the keg and take out the tube. Attach the pressure lid to the container as shown in the illustration. Page 57 The tube is bent outwards lightly to allow for easier insertion in the tap. Slide the tube through the inlet in the chromium front of the container. Built-in tap. Integrated tubes. Air release pin. Pressure gauge. Pressure chamber. Temperature control.

The FLEX 20 electronic temperature control keeps the beer consistently cold. Carlsberg and arch rivals in race for digital supremacy. In the battle for customers, brewery giants are investing heavily in filling the beer industry with apps, artificial intelligence and data tools — Published in Finans in Danish , Reinventing the Humble Beer Keg.